|Unload your Bodyguard||Field Strip|
|Drive out two steel roll pins with 3/32" punch.|
|Roll pins removed.
NOTE: "U" Spring above trigger pivot has a mind of it's own, and will fly.
Figure 20-30 minutes to locate...
|Test fit pivot into Edge trigger
Stainless steel set screw.
Uses 0.050 allen wrench
|Install trigger and pivot into frame.
Tighten Stainless steel setscrew to secure pivot in trigger,
Install linkbar. wind pivot spring counter clockwise.
Using your index finger to hold the linkbar in place on the
right side of the frame.
Place the slide lock in place.
Use your thumb to firmly hold the "U" Shaped spring in position.
|Slide the hammer spring onto the post.
Now slide frame into stock. Maintain finger pressure on frame.
|Lay safety on side of frame.
Push frame completely into stock.
Insert roll pins.
You are not done yet...
Please refer to
Adjusting your "RTK" trigger
Please note: There is only "1" reset click on the Bodyguard !
FIREARMS SAFETY IS YOUR RESPONSIBILITY
Safety must be the first and continual consideration of every person who handles firearms. Read the owner’s manual and treat every firearm with respect.
RTK Strategic LLC provides quality
Altering any product on the market comes with risks, so please understand and accept that we assume no liability for injury to the buyer or anyone residing with or operating with the buyer. The buyer is the sole responsible party for the use of their firearm with or without our parts.